Promise Technology SuperTrak SX6000 Manual de usuario descargar pdf (Pagina 20)

Offline Array Recovery Procedures—SuperTrak SX6000 and UltraTrak, Version 5a

20 of 34

Case 4: Array goes OFFLINE due to a disk power

problem.

Warning

Do NOT reconnect power to this disk while the system is running.

1. Turn off the SuperTrak PC or the UltraTrak.

2. Determine the cause of the power problem and correct it. Carefully check Y-splitter

cables on SuperTrak and disk carrier locks on UltraTrak.

3. Replace any removed disks in their original order.

4. Reboot the SuperTrak PC or the UltraTrak. The array will be restored to its previous

status.

Important

If the array goes OFFLINE rather showing its previous status, follow these

steps:

a. Shut down the system.

b. Boot (turn on) the SuperTrak PC or the UltraTrak.

c. Delete the existing array and create a new one.

Warning: This procedure may result in data loss. Follow instructions

carefully.

Refer to the sections SuperTrak BIOS Recovery Procedure on page 23,

or UltraTrak Recovery Procedure on page 29, for step-by-step

instructions.

d. Reboot the system. Array status will be FUNCTIONAL.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Sin comentarios

Promise Technology SuperTrak SX6000 Manual de usuario Pagina 20