Promise Technology VTrack M-Class M500p Manual descargar pdf (Pagina 289)

Chapter 8: Troubleshooting

281

To set up a spare drive, see “Create Spare Drive” on page 146 (WebPAM PROe)

or “Create New Spare Drive” on page 196 (CLU).

Without a Hot Spare Drive

If there is no hot spare drive of adequate capacity, you must remove the failed

drive and install an unconfigured replacement drive of the same or greater

capacity in the same slot as the failed drive. Until you install the replacement

drive, the logical drive will remain Degraded.

• If the Auto Rebuild function is ENABLED, the disk array will begin to rebuild

automatically as soon as you replace the failed drive.

• If the Auto Rebuild function is DISABLED, you must manually rebuild the

disk array after you replace the failed drive.

To enable Automatic Rebuild, see page 71 (WebPAM PROe) or page 194 (CLU).

To set Hot Spare Policy, see page 145 (WebPAM PROe) or page 196 (CLU).

Rebuild Operation

During rebuild:

• The alarm sounds a single short beep, repeated

• No warning icon displays over the Disk Array or Logical Drive

The Management Window reports the Disk Array’s Operational Status as

OK, Rebuilding.

Important

If your replacement disk drive was formerly part of a different disk

array or logical drive, you must clear the configuration data on the

replacement drive before you use it.

See “Clear Physical Drive Conditions” on page 124 (WebPAM

PROe) or “Clear Stale and PFA Conditions” on page 174 (CLU).

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 315 316

Sin comentarios

Promise Technology VTrack M-Class M500p Manual Pagina 289