Promise Technology VTrack M-Class M500p Manual descargar pdf (Pagina 180)

VTrak M-Class Product Manual

172

3. Press Ctrl-A to save your settings.

Temperature Thresholds

Temperature thresholds are the temperature levels the Controller will report as a

Warning or Critical. For most applications, the factory default settings are

recommended.

To change temperature thresholds:

1. Highlight the Enclosure Temperature Warning threshold and press the

backspace key to erase the current value.

2. Type a new interval value in degrees C.

Note the acceptable range of temperature values in the brackets. The default

values are as follows:

• Enclosure Warning, 45°C

• Enclosure Critical, 51°C

• Controller Warning, 63°C

• Controller Critical, 68°C

3. Do the same action to set the other thresholds.

4. Press Ctrl-A to save your settings.

Batteries

This feature enables you monitor and recondition the subsystem battery or

batteries.

1. From the Main Menu, highlight Subsystem Management and press Enter.

2. Highlight Enclosure Management and press Enter.

3. Highlight Batteries and press Enter.

4. Highlight the battery you want to monitor and press Enter.

5. Battery condition is expressed in the following items:

• Temperature Threshold Discharge – If battery exceeds this value while

charging, replace the battery

• Battery Temperature – Should stay below charge and discharge

thresholds

• Battery Voltage – Approximately 3900 mV is normal

• Battery Status – “FullyCharged” is normal. If it is says “Malfunction”,

replace the battery

• Remaining Capacity – When status is “FullyCharged”, capacity should

be at least 90%. If less, replace the battery

• Temperature Threshold Charge – If battery exceeds this value while

charging, replace the battery

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 315 316

Sin comentarios

Promise Technology VTrack M-Class M500p Manual Pagina 180