Promise Technology E610f Manual descargar pdf (Pagina 237)

Chapter 5: Management with the CLU

215

Making UPS Settings

These settings control how the VTrak subsystem detects the UPS unit and

responds to data reported by the UPS unit.

To make UPS settings:

1. From the Main Menu, highlight Additional Info and Management and press

Enter.

2. Highlight UPS Management and press Enter.

3. Highlight UPS Settings and press Enter.

4. Perform the following actions as required:

• Verify the Current UPS Communication method. See Note 1:

• SNMP – Network connection.

• Serial – Serial connection.

• Unknown – No connection.

• Choose a Detection Setting from the dropdown menu:

• Automatic – Default. If a UPS is detected when the subsystem

boots, the setting changes to Enable.

• Enable – Monitors UPS. Settings changes, reports warnings, and

logs events.

• Disable – Monitors UPS only.

• Type values into the Threshold fields. See Note 2:

• Running Time Remaining Threshold – Actual time below this

value resets adaptive writeback cache to writethrough.

• Warning Temperature Threshold – Actual temperature above this

value triggers a warning and logs an event.

• Loading Ratio Threshold – Actual loading ratio (percentage)

above this threshold triggers a warning and logs an event. See

Note 3.

• Battery Charge Remaining Threshold – Reserve capacity below

this percentage triggers a warning and logs an event.

• For UPS units with network cards, type the IP addresses or DNS names

in fields UPS 1 and UPS 2. See Note 4.

5. Press Ctrl-A to save your settings.

Note 1: VTrak supports multiple UPS units using network or serial

connections, but not a combination of both methods.

Note 2: Detection Setting must be set to Auto. If a UPS is detected, the

setting changes to Enable.

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 435 436

Sin comentarios

Promise Technology E610f Manual Pagina 237