Promise Technology VessRAID 1000i Series Manual descargar pdf (Pagina 207)

Chapter 5: Management with the CLU

191

Making UPS Settings

These settings control how the VessRAID subsystem detects the UPS unit and

responds to data reported by the UPS unit.

To make UPS settings:

1. From the Main Menu, highlight Additional Info and Management and press

Enter.

2. Highlight UPS Management and press Enter.

3. Highlight UPS Settings and press Enter.

4. Perform the following actions as required:

• Verify the Current UPS Communication method:

• USB – USB connection.

• Unknown – No connection.

• Choose a Detection Setting from the dropdown menu:

• Automatic – Default. If a UPS is detected when the subsystem

boots, the setting changes to Enable.

• Enable – Monitors UPS. Settings changes, reports warnings, and

logs events.

• Disable – Monitors UPS only.

• Choose an Action Mode from the dropdown menu:

• Shutdown - Shuts down the subsystem when a Threshold value is

exceeded.

• None – No additional action when Threshold value is exceeded.

• Type values into the Threshold fields. See Note 1:

• Running Time Remaining Threshold – Actual time below this value

resets adaptive writeback cache to writethrough.

• Warning Temperature Threshold – Actual temperature above this

value triggers a warning and logs an event.

• Loading Ratio Threshold – Actual loading ratio (percentage) above

this threshold triggers a warning and logs an event. See Note 2.

• Battery Charge Remaining Threshold – Reserve capacity below

this percentage triggers a warning and logs an event.

5. Press Ctrl-A to save your settings.

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 353 354

Sin comentarios

Promise Technology VessRAID 1000i Series Manual Pagina 207