Promise Technology VTRAK M610p Manual descargar pdf (Pagina 31)

Chapter 3: VTrak Setup

This chapter covers the following topics:

• Setting up the Serial Connection (below)

• Choosing DHCP or a Static IP Address (page 20)

• Setting up VTrak with the CLI (page 21)

• Setting up VTrak with the CLU (page 22)

• Creating Disk Arrays with WebPAM PROe (page 24)

Setting up the Serial Connection

VTrak has a Command Line Interface (CLI) to manage all of its functions,

including customization. A subset of the CLI is the Command Line Utility (CLU), a

user-level interface that manages your VTrak via your PC’s terminal emulation

program, such as Microsoft HyperTerminal. This procedure uses the serial cable

connection you made. See “Making Serial Cable Connections” on page 15.

1. Change your terminal emulation program settings to match the following

specifications:

• Bits per second: 115200

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow control: none

2. Start your PC’s terminal VT100 or ANSI emulation program.

3. Press Enter once to launch the CLI.

4. At the Login prompt, type administrator and press Enter.

5. At the Password prompt, type password and press Enter.

At this point, you are in the CLI. You can continue using the CLI to make

network settings or you can switch to the CLU. Go to:

• Setting up VTrak with the CLI (page 21)

• Setting up VTrak with the CLU (page 22)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 283 284

Sin comentarios

Promise Technology VTRAK M610p Manual Pagina 31