Promise Technology FastTrak TX2000 Manual de usuario descargar pdf (Pagina 12)

FastTrak TX2000™ Series User Manual

WARNING: Use of removable hard drive enclosures other than Promise

SuperSwap is not supported and may result in performance loss or other

undesired results.

3. Attach one Ultra ATA cable to each hard drive. Then attach one cable to each of the

IDE connectors on the FastTrak TX2000 controller card. The colored edge of the

cable(s) indicates pin 1 (see below), and the blue cable connector must be attached

to the FastTrak TX2000 connector.

IDE 2

Figure 2

NOTE: You must use an 80-wire, 40-pin cable when connecting an Ultra

ATA/133 hard drive to the FastTrak TX2000 controller card. The FastTrak

TX2000 package contains two 80-wire, 40-pin cables.

LED Pin 1

IDE 2 IDE 1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 69 70

Sin comentarios

Promise Technology FastTrak TX2000 Manual de usuario Pagina 12