
R1.00
3/26/2014
2. Release version 1.08.0000.00
The following are changes that have been made since the 1.05.0000.00 Release.
2.1. Firmware Specific Fixes
Fixed a defect seen where adding an A3800 to a switch that includes Ex30’s with a large number of
LUNs could cause the A3800 Controllers to crash .
Changed Event to indicate "Forced Offline" instead of "Dead" when a PD is forced offline.
Fixed defect where a controller might reboot again following a controller failover due to a heartbeat
Fixed defect where the Slave controller could get held on reset while disabling "cache Mirroring" in the
subsytem
Changed Automatic firmware synchronization event from “critical” severity to “information”.
Fixed defect seen on some drives where a Medium Error on a drive could cause the drive to be marked
"Dead".
Fixed a defect where Logging into CLI or GUI, adding or deleting the FS license, or create a new file
system caused "unknown" severity Events to pop up
SAN Events have now been added
Fixed defect where a controller could be held on reset when downgrading the firmware to an earlier
build
Corrected BIOS version display
Fixed a defect where a Media Patrol could fail with PD's that are greater than 2 TB
Fixed BIOS date display for CLI command "ptiflash -a versioninfo"
Fixed defect where a controller could crash or reboot after relocating a Transport Ready PD to a free
slot.
Fixed defect where if you boot the A3800 before you boot an attached Jx30 JBOD, the arrays might not
come online without an additional reboot.
Fixed defect seen if you removed an array and its dedicated spare from the A3800 after transporting
it, then insert an Unconfigured disk to the slot where the spare was, a stale entry of that spare was
listed
2.2. Software Specific Fixes
Improvements made to more clearly define GUI Access limitations for different levels of users.
Comentarios a estos manuales