Promise Technology J310s J610s Manual de usuario descargar pdf (Pagina 38)

VTrak J610s, J310s Product Manual

cli>cable

CN#1 Cable Length = 1 meter

CN#2 Cable Length = 3 meter

Note the cable length change for CN2.

Enclosure Command

The Enclosure command:

• Displays information about the J610s or J310s enclosure (below)

• Enables you to make enclosure settings (page 36)

Information

The Enclosure command displays information about the J610s or J310s

enclosure, including:

The CLI reports information for the I/O module to which it is connected and for

the rest of the components in the J310s enclosure.

Under SAS specifications, both I/O modules are active at the same time. For

management purposes, the default primary I/O module role is Primary. If a

second I/O module is present, its role is Secondary. See the arrow below for I/O

Module Role in the display. Also see “Setting Up Data Cable Connections” on

page 20.

In a J610s or J310s unit with two I/O modules, if the primary I/O module fails or is

removed, the remaining I/O module becomes the default primary I/O module and

assumes the Primary role. If the other I/O module is repaired or replaced, it

becomes the secondary I/O module and assumes the Secondary role.

At the cli> prompt, type enclosure and press Enter.

cli> enclosure

-------------------------------------------------------------------------------------

Time Since Power Up: 1 hour 46 minutes 36 seconds

Enclosure: J310s-12Bay

• Time since power-up

• Enclosure type

• I/O module information

• PSU (power supply) status and

fan speeds

• Blower status and fan speeds

• Temperature sensor readings

• Temperature threshold settings

• Voltage sensor readings

• Expander SAS addresses

• Attached SAS addresses

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Sin comentarios

Promise Technology J310s J610s Manual de usuario Pagina 38